| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
nilfs2: fix potential oob read in nilfs_btree_check_delete()
The function nilfs_btree_check_delete(), which checks whether degeneration
to direct mapping occurs before deleting a b-tree entry, causes memory
access outside the block buffer when retrieving the maximum key if the
root node has no entries.
This does not usually happen because b-tree mappings with 0 child nodes
are never created by mkfs.nilfs2 or nilfs2 itself. However, it can happen
if the b-tree root node read from a device is configured that way, so fix
this potential issue by adding a check for that case. |
| In the Linux kernel, the following vulnerability has been resolved:
PCI: kirin: Fix buffer overflow in kirin_pcie_parse_port()
Within kirin_pcie_parse_port(), the pcie->num_slots is compared to
pcie->gpio_id_reset size (MAX_PCI_SLOTS) which is correct and would lead
to an overflow.
Thus, fix condition to pcie->num_slots + 1 >= MAX_PCI_SLOTS and move
pcie->num_slots increment below the if-statement to avoid out-of-bounds
array access.
Found by Linux Verification Center (linuxtesting.org) with SVACE.
[kwilczynski: commit log] |
| In the Linux kernel, the following vulnerability has been resolved:
jfs: fix out-of-bounds in dbNextAG() and diAlloc()
In dbNextAG() , there is no check for the case where bmp->db_numag is
greater or same than MAXAG due to a polluted image, which causes an
out-of-bounds. Therefore, a bounds check should be added in dbMount().
And in dbNextAG(), a check for the case where agpref is greater than
bmp->db_numag should be added, so an out-of-bounds exception should be
prevented.
Additionally, a check for the case where agno is greater or same than
MAXAG should be added in diAlloc() to prevent out-of-bounds. |
| XStream is a simple library to serialize objects to XML and back again. This vulnerability may allow a remote attacker to terminate the application with a stack overflow error resulting in a denial of service only by manipulating the processed input stream when XStream is configured to use the BinaryStreamDriver. XStream 1.4.21 has been patched to detect the manipulation in the binary input stream causing the the stack overflow and raises an InputManipulationException instead. Users are advised to upgrade. Users unable to upgrade may catch the StackOverflowError in the client code calling XStream if XStream is configured to use the BinaryStreamDriver. |
| An issue was discovered in psi/zfile.c in Artifex Ghostscript before 10.04.0. Out-of-bounds data access in filenameforall can lead to arbitrary code execution. |
| An issue was discovered in psi/zcolor.c in Artifex Ghostscript before 10.04.0. There is an out-of-bounds read when reading color in Indexed color space. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/amd/display: Correct the defined value for AMDGPU_DMUB_NOTIFICATION_MAX
[Why & How]
It actually exposes '6' types in enum dmub_notification_type. Not 5. Using smaller
number to create array dmub_callback & dmub_thread_offload has potential to access
item out of array bound. Fix it. |
| In the Linux kernel, the following vulnerability has been resolved:
platform/x86: panasonic-laptop: Fix SINF array out of bounds accesses
The panasonic laptop code in various places uses the SINF array with index
values of 0 - SINF_CUR_BRIGHT(0x0d) without checking that the SINF array
is big enough.
Not all panasonic laptops have this many SINF array entries, for example
the Toughbook CF-18 model only has 10 SINF array entries. So it only
supports the AC+DC brightness entries and mute.
Check that the SINF array has a minimum size which covers all AC+DC
brightness entries and refuse to load if the SINF array is smaller.
For higher SINF indexes hide the sysfs attributes when the SINF array
does not contain an entry for that attribute, avoiding show()/store()
accessing the array out of bounds and add bounds checking to the probe()
and resume() code accessing these. |
| In the Linux kernel, the following vulnerability has been resolved:
spi: nxp-fspi: fix the KASAN report out-of-bounds bug
Change the memcpy length to fix the out-of-bounds issue when writing the
data that is not 4 byte aligned to TX FIFO.
To reproduce the issue, write 3 bytes data to NOR chip.
dd if=3b of=/dev/mtd0
[ 36.926103] ==================================================================
[ 36.933409] BUG: KASAN: slab-out-of-bounds in nxp_fspi_exec_op+0x26ec/0x2838
[ 36.940514] Read of size 4 at addr ffff00081037c2a0 by task dd/455
[ 36.946721]
[ 36.948235] CPU: 3 UID: 0 PID: 455 Comm: dd Not tainted 6.11.0-rc5-gc7b0e37c8434 #1070
[ 36.956185] Hardware name: Freescale i.MX8QM MEK (DT)
[ 36.961260] Call trace:
[ 36.963723] dump_backtrace+0x90/0xe8
[ 36.967414] show_stack+0x18/0x24
[ 36.970749] dump_stack_lvl+0x78/0x90
[ 36.974451] print_report+0x114/0x5cc
[ 36.978151] kasan_report+0xa4/0xf0
[ 36.981670] __asan_report_load_n_noabort+0x1c/0x28
[ 36.986587] nxp_fspi_exec_op+0x26ec/0x2838
[ 36.990800] spi_mem_exec_op+0x8ec/0xd30
[ 36.994762] spi_mem_no_dirmap_read+0x190/0x1e0
[ 36.999323] spi_mem_dirmap_write+0x238/0x32c
[ 37.003710] spi_nor_write_data+0x220/0x374
[ 37.007932] spi_nor_write+0x110/0x2e8
[ 37.011711] mtd_write_oob_std+0x154/0x1f0
[ 37.015838] mtd_write_oob+0x104/0x1d0
[ 37.019617] mtd_write+0xb8/0x12c
[ 37.022953] mtdchar_write+0x224/0x47c
[ 37.026732] vfs_write+0x1e4/0x8c8
[ 37.030163] ksys_write+0xec/0x1d0
[ 37.033586] __arm64_sys_write+0x6c/0x9c
[ 37.037539] invoke_syscall+0x6c/0x258
[ 37.041327] el0_svc_common.constprop.0+0x160/0x22c
[ 37.046244] do_el0_svc+0x44/0x5c
[ 37.049589] el0_svc+0x38/0x78
[ 37.052681] el0t_64_sync_handler+0x13c/0x158
[ 37.057077] el0t_64_sync+0x190/0x194
[ 37.060775]
[ 37.062274] Allocated by task 455:
[ 37.065701] kasan_save_stack+0x2c/0x54
[ 37.069570] kasan_save_track+0x20/0x3c
[ 37.073438] kasan_save_alloc_info+0x40/0x54
[ 37.077736] __kasan_kmalloc+0xa0/0xb8
[ 37.081515] __kmalloc_noprof+0x158/0x2f8
[ 37.085563] mtd_kmalloc_up_to+0x120/0x154
[ 37.089690] mtdchar_write+0x130/0x47c
[ 37.093469] vfs_write+0x1e4/0x8c8
[ 37.096901] ksys_write+0xec/0x1d0
[ 37.100332] __arm64_sys_write+0x6c/0x9c
[ 37.104287] invoke_syscall+0x6c/0x258
[ 37.108064] el0_svc_common.constprop.0+0x160/0x22c
[ 37.112972] do_el0_svc+0x44/0x5c
[ 37.116319] el0_svc+0x38/0x78
[ 37.119401] el0t_64_sync_handler+0x13c/0x158
[ 37.123788] el0t_64_sync+0x190/0x194
[ 37.127474]
[ 37.128977] The buggy address belongs to the object at ffff00081037c2a0
[ 37.128977] which belongs to the cache kmalloc-8 of size 8
[ 37.141177] The buggy address is located 0 bytes inside of
[ 37.141177] allocated 3-byte region [ffff00081037c2a0, ffff00081037c2a3)
[ 37.153465]
[ 37.154971] The buggy address belongs to the physical page:
[ 37.160559] page: refcount:1 mapcount:0 mapping:0000000000000000 index:0x0 pfn:0x89037c
[ 37.168596] flags: 0xbfffe0000000000(node=0|zone=2|lastcpupid=0x1ffff)
[ 37.175149] page_type: 0xfdffffff(slab)
[ 37.179021] raw: 0bfffe0000000000 ffff000800002500 dead000000000122 0000000000000000
[ 37.186788] raw: 0000000000000000 0000000080800080 00000001fdffffff 0000000000000000
[ 37.194553] page dumped because: kasan: bad access detected
[ 37.200144]
[ 37.201647] Memory state around the buggy address:
[ 37.206460] ffff00081037c180: fa fc fc fc fa fc fc fc fa fc fc fc fa fc fc fc
[ 37.213701] ffff00081037c200: fa fc fc fc 05 fc fc fc 03 fc fc fc 02 fc fc fc
[ 37.220946] >ffff00081037c280: 06 fc fc fc 03 fc fc fc fc fc fc fc fc fc fc fc
[ 37.228186] ^
[ 37.232473] ffff00081037c300: fc fc fc fc fc fc fc fc fc fc fc fc fc fc fc fc
[ 37.239718] ffff00081037c380: fc fc fc fc fc fc fc fc fc fc fc fc fc fc fc fc
[ 37.246962] ==============================================================
---truncated--- |
| In the Linux kernel, the following vulnerability has been resolved:
usb: gadget: aspeed_udc: validate endpoint index for ast udc
We should verify the bound of the array to assure that host
may not manipulate the index to point past endpoint array.
Found by static analysis. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/amd/display: Check gpio_id before used as array index
[WHY & HOW]
GPIO_ID_UNKNOWN (-1) is not a valid value for array index and therefore
should be checked in advance.
This fixes 5 OVERRUN issues reported by Coverity. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/amd/display: Stop amdgpu_dm initialize when stream nums greater than 6
[Why]
Coverity reports OVERRUN warning. Should abort amdgpu_dm
initialize.
[How]
Return failure to amdgpu_dm_init. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/amd/display: Check num_valid_sets before accessing reader_wm_sets[]
[WHY & HOW]
num_valid_sets needs to be checked to avoid a negative index when
accessing reader_wm_sets[num_valid_sets - 1].
This fixes an OVERRUN issue reported by Coverity. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/amd/display: Check msg_id before processing transcation
[WHY & HOW]
HDCP_MESSAGE_ID_INVALID (-1) is not a valid msg_id nor is it a valid
array index, and it needs checking before used.
This fixes 4 OVERRUN issues reported by Coverity. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/amd/display: Add array index check for hdcp ddc access
[Why]
Coverity reports OVERRUN warning. Do not check if array
index valid.
[How]
Check msg_id valid and valid array index. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/amdgpu: Fix out-of-bounds read of df_v1_7_channel_number
Check the fb_channel_number range to avoid the array out-of-bounds
read error |
| In the Linux kernel, the following vulnerability has been resolved:
drm/amdgpu: fix ucode out-of-bounds read warning
Clear warning that read ucode[] may out-of-bounds. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/amdgpu: fix mc_data out-of-bounds read warning
Clear warning that read mc_data[i-1] may out-of-bounds. |
| In the Linux kernel, the following vulnerability has been resolved:
net: dsa: mv88e6xxx: Fix out-of-bound access
If an ATU violation was caused by a CPU Load operation, the SPID could
be larger than DSA_MAX_PORTS (the size of mv88e6xxx_chip.ports[] array). |
| A serial interface can be accessed with physical access to the PCB of Wattsense Bridge devices. After connecting to the interface, access to the bootloader is possible, as well as a Linux login prompt. The bootloader access can be used to gain a root shell on the device. This issue is fixed in recent firmware versions BSP >= 6.4.1. |
