| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: L2CAP: Fix missing key size check for L2CAP_LE_CONN_REQ
This adds a check for encryption key size upon receiving
L2CAP_LE_CONN_REQ which is required by L2CAP/LE/CFC/BV-15-C which
expects L2CAP_CR_LE_BAD_KEY_SIZE. |
| In the Linux kernel, the following vulnerability has been resolved:
net: ioam6: fix OOB and missing lock
When trace->type.bit6 is set:
if (trace->type.bit6) {
...
queue = skb_get_tx_queue(dev, skb);
qdisc = rcu_dereference(queue->qdisc);
This code can lead to an out-of-bounds access of the dev->_tx[] array
when is_input is true. In such a case, the packet is on the RX path and
skb->queue_mapping contains the RX queue index of the ingress device. If
the ingress device has more RX queues than the egress device (dev) has
TX queues, skb_get_queue_mapping(skb) will exceed dev->num_tx_queues.
Add a check to avoid this situation since skb_get_tx_queue() does not
clamp the index. This issue has also revealed that per queue visibility
cannot be accurate and will be replaced later as a new feature.
While at it, add missing lock around qdisc_qstats_qlen_backlog(). The
function __ioam6_fill_trace_data() is called from both softirq and
process contexts, hence the use of spin_lock_bh() here. |
| In the Linux kernel, the following vulnerability has been resolved:
ocfs2: validate inline data i_size during inode read
When reading an inode from disk, ocfs2_validate_inode_block() performs
various sanity checks but does not validate the size of inline data. If
the filesystem is corrupted, an inode's i_size can exceed the actual
inline data capacity (id_count).
This causes ocfs2_dir_foreach_blk_id() to iterate beyond the inline data
buffer, triggering a use-after-free when accessing directory entries from
freed memory.
In the syzbot report:
- i_size was 1099511627576 bytes (~1TB)
- Actual inline data capacity (id_count) is typically <256 bytes
- A garbage rec_len (54648) caused ctx->pos to jump out of bounds
- This triggered a UAF in ocfs2_check_dir_entry()
Fix by adding a validation check in ocfs2_validate_inode_block() to ensure
inodes with inline data have i_size <= id_count. This catches the
corruption early during inode read and prevents all downstream code from
operating on invalid data. |
| In the Linux kernel, the following vulnerability has been resolved:
ocfs2: fix out-of-bounds write in ocfs2_write_end_inline
KASAN reports a use-after-free write of 4086 bytes in
ocfs2_write_end_inline, called from ocfs2_write_end_nolock during a
copy_file_range splice fallback on a corrupted ocfs2 filesystem mounted on
a loop device. The actual bug is an out-of-bounds write past the inode
block buffer, not a true use-after-free. The write overflows into an
adjacent freed page, which KASAN reports as UAF.
The root cause is that ocfs2_try_to_write_inline_data trusts the on-disk
id_count field to determine whether a write fits in inline data. On a
corrupted filesystem, id_count can exceed the physical maximum inline data
capacity, causing writes to overflow the inode block buffer.
Call trace (crash path):
vfs_copy_file_range (fs/read_write.c:1634)
do_splice_direct
splice_direct_to_actor
iter_file_splice_write
ocfs2_file_write_iter
generic_perform_write
ocfs2_write_end
ocfs2_write_end_nolock (fs/ocfs2/aops.c:1949)
ocfs2_write_end_inline (fs/ocfs2/aops.c:1915)
memcpy_from_folio <-- KASAN: write OOB
So add id_count upper bound check in ocfs2_validate_inode_block() to
alongside the existing i_size check to fix it. |
| In the Linux kernel, the following vulnerability has been resolved:
comedi: me_daq: Fix potential overrun of firmware buffer
`me2600_xilinx_download()` loads the firmware that was requested by
`request_firmware()`. It is possible for it to overrun the source
buffer because it blindly trusts the file format. It reads a data
stream length from the first 4 bytes into variable `file_length` and
reads the data stream contents of length `file_length` from offset 16
onwards. Although it checks that the supplied firmware is at least 16
bytes long, it does not check that it is long enough to contain the data
stream.
Add a test to ensure that the supplied firmware is long enough to
contain the header and the data stream. On failure, log an error and
return `-EINVAL`. |
| In the Linux kernel, the following vulnerability has been resolved:
ext4: reject mount if bigalloc with s_first_data_block != 0
bigalloc with s_first_data_block != 0 is not supported, reject mounting
it. |
| In the Linux kernel, the following vulnerability has been resolved:
vxlan: validate ND option lengths in vxlan_na_create
vxlan_na_create() walks ND options according to option-provided
lengths. A malformed option can make the parser advance beyond the
computed option span or use a too-short source LLADDR option payload.
Validate option lengths against the remaining NS option area before
advancing, and only read source LLADDR when the option is large enough
for an Ethernet address. |
| In the Linux kernel, the following vulnerability has been resolved:
ext4: validate p_idx bounds in ext4_ext_correct_indexes
ext4_ext_correct_indexes() walks up the extent tree correcting
index entries when the first extent in a leaf is modified. Before
accessing path[k].p_idx->ei_block, there is no validation that
p_idx falls within the valid range of index entries for that
level.
If the on-disk extent header contains a corrupted or crafted
eh_entries value, p_idx can point past the end of the allocated
buffer, causing a slab-out-of-bounds read.
Fix this by validating path[k].p_idx against EXT_LAST_INDEX() at
both access sites: before the while loop and inside it. Return
-EFSCORRUPTED if the index pointer is out of range, consistent
with how other bounds violations are handled in the ext4 extent
tree code. |
| In the Linux kernel, the following vulnerability has been resolved:
scsi: ibmvfc: Fix OOB access in ibmvfc_discover_targets_done()
A malicious or compromised VIO server can return a num_written value in the
discover targets MAD response that exceeds max_targets. This value is
stored directly in vhost->num_targets without validation, and is then used
as the loop bound in ibmvfc_alloc_targets() to index into disc_buf[], which
is only allocated for max_targets entries. Indices at or beyond max_targets
access kernel memory outside the DMA-coherent allocation. The
out-of-bounds data is subsequently embedded in Implicit Logout and PLOGI
MADs that are sent back to the VIO server, leaking kernel memory.
Fix by clamping num_written to max_targets before storing it. |
| In the Linux kernel, the following vulnerability has been resolved:
usb: typec: ucsi: validate connector number in ucsi_notify_common()
The connector number extracted from CCI via UCSI_CCI_CONNECTOR() is a
7-bit field (0-127) that is used to index into the connector array in
ucsi_connector_change(). However, the array is only allocated for the
number of connectors reported by the device (typically 2-4 entries).
A malicious or malfunctioning device could report an out-of-range
connector number in the CCI, causing an out-of-bounds array access in
ucsi_connector_change().
Add a bounds check in ucsi_notify_common(), the central point where CCI
is parsed after arriving from hardware, so that bogus connector numbers
are rejected before they propagate further. |
| Insufficient validation of untrusted input in ChromeDriver in Google Chrome on Windows prior to 148.0.7778.96 allowed a remote attacker to execute arbitrary code via a crafted HTML page. (Chromium security severity: Low) |
| Insufficient validation of untrusted input in TabGroups in Google Chrome prior to 148.0.7778.96 allowed a remote attacker to perform UI spoofing via malicious network traffic. (Chromium security severity: Low) |
| Insufficient validation of untrusted input in Cast in Google Chrome prior to 148.0.7778.96 allowed a remote attacker who had compromised the renderer process to perform privilege escalation via a crafted HTML page. (Chromium security severity: Low) |
| Insufficient validation of untrusted input in SiteIsolation in Google Chrome prior to 148.0.7778.96 allowed a remote attacker who had compromised the renderer process to bypass site isolation via a crafted HTML page. (Chromium security severity: Low) |
| In the Linux kernel, the following vulnerability has been resolved:
smb: client: validate the whole DACL before rewriting it in cifsacl
build_sec_desc() and id_mode_to_cifs_acl() derive a DACL pointer from a
server-supplied dacloffset and then use the incoming ACL to rebuild the
chmod/chown security descriptor.
The original fix only checked that the struct smb_acl header fits before
reading dacl_ptr->size or dacl_ptr->num_aces. That avoids the immediate
header-field OOB read, but the rewrite helpers still walk ACEs based on
pdacl->num_aces with no structural validation of the incoming DACL body.
A malicious server can return a truncated DACL that still contains a
header, claims one or more ACEs, and then drive
replace_sids_and_copy_aces() or set_chmod_dacl() past the validated
extent while they compare or copy attacker-controlled ACEs.
Factor the DACL structural checks into validate_dacl(), extend them to
validate each ACE against the DACL bounds, and use the shared validator
before the chmod/chown rebuild paths. parse_dacl() reuses the same
validator so the read-side parser and write-side rewrite paths agree on
what constitutes a well-formed incoming DACL. |
| In the Linux kernel, the following vulnerability has been resolved:
net: usb: pegasus: enable basic endpoint checking
pegasus_probe() fills URBs with hardcoded endpoint pipes without
verifying the endpoint descriptors:
- usb_rcvbulkpipe(dev, 1) for RX data
- usb_sndbulkpipe(dev, 2) for TX data
- usb_rcvintpipe(dev, 3) for status interrupts
A malformed USB device can present these endpoints with transfer types
that differ from what the driver assumes.
Add a pegasus_usb_ep enum for endpoint numbers, replacing magic
constants throughout. Add usb_check_bulk_endpoints() and
usb_check_int_endpoints() calls before any resource allocation to
verify endpoint types before use, rejecting devices with mismatched
descriptors at probe time, and avoid triggering assertion.
Similar fix to
- commit 90b7f2961798 ("net: usb: rtl8150: enable basic endpoint checking")
- commit 9e7021d2aeae ("net: usb: catc: enable basic endpoint checking") |
| In the Linux kernel, the following vulnerability has been resolved:
minix: Add required sanity checking to minix_check_superblock()
The fs/minix implementation of the minix filesystem does not currently
support any other value for s_log_zone_size than 0. This is also the
only value supported in util-linux; see mkfs.minix.c line 511. In
addition, this patch adds some sanity checking for the other minix
superblock fields, and moves the minix_blocks_needed() checks for the
zmap and imap also to minix_check_super_block().
This also closes a related syzbot bug report. |
| In the Linux kernel, the following vulnerability has been resolved:
net: lapbether: handle NETDEV_PRE_TYPE_CHANGE
lapbeth_data_transmit() expects the underlying device type
to be ARPHRD_ETHER.
Returning NOTIFY_BAD from lapbeth_device_event() makes sure
bonding driver can not break this expectation. |
| Insufficient validation of untrusted input in Updater in Google Chrome on Mac prior to 148.0.7778.96 allowed a local attacker to perform OS-level privilege escalation via a malicious file. (Chromium security severity: Low) |
| Insufficient validation of untrusted input in Media in Google Chrome on Android prior to 148.0.7778.96 allowed a remote attacker who had compromised the renderer process to potentially perform a sandbox escape via a crafted HTML page. (Chromium security severity: High) |
