Export limit exceeded: 14504 CVEs match your query. Please refine your search to export 10,000 CVEs or fewer.
Search
Search Results (14504 CVEs found)
| CVE | Vendors | Products | Updated | CVSS v3.1 |
|---|---|---|---|---|
| CVE-2026-34971 | 1 Bytecodealliance | 1 Wasmtime | 2026-04-15 | 7.8 High |
| Wasmtime is a runtime for WebAssembly. From 32.0.0 to before 36.0.7, 42.0.2, and 43.0.1, Wasmtime's Cranelift compilation backend contains a bug on aarch64 when performing a certain shape of heap accesses which means that the wrong address is accessed. When combined with explicit bounds checks a guest WebAssembly module this can create a situation where there are two diverging computations for the same address: one for the address to bounds-check and one for the address to load. This difference in address being operated on means that a guest module can pass a bounds check but then load a different address. Combined together this enables an arbitrary read/write primitive for guest WebAssembly when accesssing host memory. This is a sandbox escape as guests are able to read/write arbitrary host memory. This vulnerability has a few ingredients, all of which must be met, for this situation to occur and bypass the sandbox restrictions. This miscompiled shape of load only occurs on 64-bit WebAssembly linear memories, or when Config::wasm_memory64 is enabled. 32-bit WebAssembly is not affected. Spectre mitigations or signals-based-traps must be disabled. When spectre mitigations are enabled then the offending shape of load is not generated. When signals-based-traps are disabled then spectre mitigations are also automatically disabled. The specific bug in Cranelift is a miscompile of a load of the shape load(iadd(base, ishl(index, amt))) where amt is a constant. The amt value is masked incorrectly to test if it's a certain value, and this incorrect mask means that Cranelift can pattern-match this lowering rule during instruction selection erroneously, diverging from WebAssembly's and Cranelift's semantics. This incorrect lowering would, for example, load an address much further away than intended as the correct address's computation would have wrapped around to a smaller value insetad. This vulnerability is fixed in 36.0.7, 42.0.2, and 43.0.1. | ||||
| CVE-2026-34987 | 1 Bytecodealliance | 1 Wasmtime | 2026-04-15 | 9.9 Critical |
| Wasmtime is a runtime for WebAssembly. From 25.0.0 to before 36.0.7, 42.0.2, and 43.0.1, Wasmtime with its Winch (baseline) non-default compiler backend may allow properly constructed guest Wasm to access host memory outside of its linear-memory sandbox. This vulnerability requires use of the Winch compiler (-Ccompiler=winch). By default, Wasmtime uses its Cranelift backend, not Winch. With Winch, the same incorrect assumption is present in theory on both aarch64 and x86-64. The aarch64 case has an observed-working proof of concept, while the x86-64 case is theoretical and may not be reachable in practice. This Winch compiler bug can allow the Wasm guest to access memory before or after the linear-memory region, independently of whether pre- or post-guard regions are configured. The accessible range in the initial bug proof-of-concept is up to 32KiB before the start of memory, or ~4GiB after the start of memory, independently of the size of pre- or post-guard regions or the use of explicit or guard-region-based bounds checking. However, the underlying bug assumes a 32-bit memory offset stored in a 64-bit register has its upper bits cleared when it may not, and so closely related variants of the initial proof-of-concept may be able to access truly arbitrary memory in-process. This could result in a host process segmentation fault (DoS), an arbitrary data leak from the host process, or with a write, potentially an arbitrary RCE. This vulnerability is fixed in 36.0.7, 42.0.2, and 43.0.1. | ||||
| CVE-2026-35195 | 1 Bytecodealliance | 1 Wasmtime | 2026-04-15 | 5.4 Medium |
| Wasmtime is a runtime for WebAssembly. Prior to 24.0.7, 36.0.7, 42.0.2, and 43.0.1, Wasmtime's implementation of transcoding strings between components contains a bug where the return value of a guest component's realloc is not validated before the host attempts to write through the pointer. This enables a guest to cause the host to write arbitrary transcoded string bytes to an arbitrary location up to 4GiB away from the base of linear memory. These writes on the host could hit unmapped memory or could corrupt host data structures depending on Wasmtime's configuration. Wasmtime by default reserves 4GiB of virtual memory for a guest's linear memory meaning that this bug will by default on hosts cause the host to hit unmapped memory and abort the process due to an unhandled fault. Wasmtime can be configured, however, to reserve less memory for a guest and to remove all guard pages, so some configurations of Wasmtime may lead to corruption of data outside of a guest's linear memory, such as host data structures or other guests's linear memories. This vulnerability is fixed in 24.0.7, 36.0.7, 42.0.2, and 43.0.1. | ||||
| CVE-2025-64129 | 1 Zenitel | 1 Tciv-3+ | 2026-04-15 | 7.6 High |
| Zenitel TCIV-3+ is vulnerable to an out-of-bounds write vulnerability, which could allow a remote attacker to crash the device. | ||||
| CVE-2025-55118 | 1 Bmc | 1 Control-m/agent | 2026-04-15 | 8.9 High |
| Memory corruptions can be remotely triggered in the Control-M/Agent when SSL/TLS communication is configured. The issue occurs in the following cases: * Control-M/Agent 9.0.20: SSL/TLS configuration is set to the non-default setting "use_openssl=n"; * Control-M/Agent 9.0.21 and 9.0.22: Agent router configuration uses the non-default settings "JAVA_AR=N" and "use_openssl=n" | ||||
| CVE-2025-59729 | 1 Ffmpeg | 1 Ffmpeg | 2026-04-15 | 6.8 Medium |
| When parsing the header for a DHAV file, there's an integer underflow in offset calculation that leads to reading the duration from before the start of the allocated buffer. If we load a DHAV file that is larger than MAX_DURATION_BUFFER_SIZE bytes (0x100000) for example 0x101000 bytes, then at [0] we have size = 0x101000. At [1] we have end_buffer_size = 0x100000, and at [2] we have end_buffer_pos = 0x1000. The loop then scans backwards through the buffer looking for the dhav tag; when it is found, we'll calculate end_pos based on a 32-bit offset read from the buffer. There is subsequently a check [3] that end_pos is within the section of the file that has been copied into end_buffer, but it only correctly handles the cases where end_pos is before the start of the file or after the section copied into end_buffer, and not the case where end_pos is within the the file, but before the section copied into end_buffer. If we provide such an offset, (end_pos - end_buffer_pos) can underflow, resulting in the subsequent access at [4] occurring before the beginning of the allocation. We recommend upgrading to version 8.0 or beyond. | ||||
| CVE-2024-20496 | 1 Cisco | 2 Sd-wan Vedge Cloud, Sd-wan Vedge Router | 2026-04-15 | 6.1 Medium |
| A vulnerability in the UDP packet validation code of Cisco SD-WAN vEdge Software could allow an unauthenticated, adjacent attacker to cause a denial of service (DoS) condition on an affected system. This vulnerability is due to incorrect handling of a specific type of malformed UDP packet. An attacker in a machine-in-the-middle position could exploit this vulnerability by sending crafted UDP packets to an affected device. A successful exploit could allow the attacker to cause the device to reboot, resulting in a DoS condition on the affected system. | ||||
| CVE-2024-1848 | 2026-04-15 | 7.8 High | ||
| Heap-based Buffer Overflow, Memory Corruption, Out-Of-Bounds Read, Out-Of-Bounds Write, Stack-based Buffer Overflow, Type Confusion, Uninitialized Variable, Use-After-Free vulnerabilities exist in the file reading procedure in SOLIDWORKS Desktop on Release SOLIDWORKS 2024. These vulnerabilities could allow an attacker to execute arbitrary code while opening a specially crafted CATPART, DWG, DXF, IPT, JT, SAT, SLDDRW, SLDPRT, STL, STP, X_B or X_T file. | ||||
| CVE-2023-29929 | 1 Kemptechnologies | 1 Loadmaster | 2026-04-15 | 7.5 High |
| Buffer Overflow vulnerability found in Kemptechnologies Loadmaster before v.7.2.60.0 allows a remote attacker to casue a denial of service via the libkemplink.so, isreverse library. | ||||
| CVE-2021-46772 | 2026-04-15 | 3.9 Low | ||
| Insufficient input validation in the ABL may allow a privileged attacker with access to the BIOS menu or UEFI shell to tamper with the structure headers in SPI ROM causing an out of bounds memory read and write, potentially resulting in memory corruption or denial of service. | ||||
| CVE-2025-59730 | 1 Ffmpeg | 1 Ffmpeg | 2026-04-15 | 6.5 Medium |
| When decoding a frame for a SANM file (ANIM v0 variant), the decoded data can be larger than the buffer allocated for it. Frames encoded with codec 48 can specify their resolution (width x height). A buffer of appropriate size is allocated depending on the resolution. This codec can encode the frame contents using a run-length encoding algorithm. There are no checks that the decoded frame fits in the allocated buffer, leading to a heap-buffer-overflow. process_frame_obj initializes the buffers based on the frame resolution: We recommend upgrading to version 8.0 or beyond. | ||||
| CVE-2025-3017 | 2026-04-15 | 5.3 Medium | ||
| A vulnerability, which was classified as critical, has been found in TA-Lib up to 0.6.4. This issue affects the function setInputBuffer of the file src/tools/ta_regtest/ta_test_func/test_minmax.c of the component ta_regtest. The manipulation leads to out-of-bounds write. It is possible to launch the attack on the local host. The exploit has been disclosed to the public and may be used. The identifier of the patch is 5879180e9070ec35d52948f2f57519713256a0f1. It is recommended to apply a patch to fix this issue. | ||||
| CVE-2021-47781 | 1 Cmder | 1 Cmder | 2026-04-15 | 9.8 Critical |
| Cmder Console Emulator 1.3.18 contains a buffer overflow vulnerability that allows attackers to trigger a denial of service condition through a maliciously crafted .cmd file. Attackers can create a specially constructed .cmd file with repeated characters to overwhelm the console emulator's buffer and crash the application. | ||||
| CVE-2023-20513 | 2026-04-15 | 3.3 Low | ||
| An insufficient bounds check in PMFW (Power Management Firmware) may allow an attacker to utilize a malicious VF (virtualization function) to send a malformed message, potentially resulting in a denial of service. | ||||
| CVE-2025-42940 | 1 Sap | 1 Commoncryptolib | 2026-04-15 | 7.5 High |
| SAP CommonCryptoLib does not perform necessary boundary checks during pre-authentication parsing of manipulated ASN.1 data over the network. This may result in memory corruption followed by an application crash, hence leading to a high impact on availability. There is no impact on confidentiality or integrity. | ||||
| CVE-2024-0142 | 2026-04-15 | 6.8 Medium | ||
| NVIDIA nvJPEG2000 library contains a vulnerability where an attacker can cause an out-of-bounds write issue by means of a specially crafted JPEG2000 file. A successful exploit of this vulnerability might lead to code execution and data tampering. | ||||
| CVE-2025-0034 | 1 Amd | 2 Instinct Mi300x, Instinct Mi325x | 2026-04-15 | 4.7 Medium |
| Insufficient parameter sanitization in TEE SOC Driver could allow an attacker to issue a malformed DRV_SOC_CMD_ID_SRIOV_SPATIAL_PART and cause read or write past the end of allocated arrays, potentially resulting in a loss of platform integrity or denial of service. | ||||
| CVE-2025-53367 | 2026-04-15 | N/A | ||
| DjVuLibre is a GPL implementation of DjVu, a web-centric format for distributing documents and images. Prior to version 3.5.29, the MMRDecoder::scanruns method is affected by an OOB-write vulnerability, because it does not check that the xr pointer stays within the bounds of the allocated buffer. This can lead to writes beyond the allocated memory, resulting in a heap corruption condition. An out-of-bounds read with pr is also possible for the same reason. This issue has been patched in version 3.5.29. | ||||
| CVE-2021-47719 | 1 Commax | 1 Webviewer Activex Control | 2026-04-15 | N/A |
| COMMAX WebViewer ActiveX Control 2.1.4.5 contains a buffer overflow vulnerability that allows attackers to execute arbitrary code by providing excessively long string arrays through multiple functions. Attackers can exploit boundary errors in Commax_WebViewer.ocx to cause buffer overflow conditions and potentially gain code execution. | ||||
| CVE-2024-55412 | 2026-04-15 | 7.8 High | ||
| A vulnerability exits in driver snxpsamd.sys in SUNIX Serial Driver x64 - 10.1.0.0, which allows low-privileged users to read and write arbitary i/o port via specially crafted IOCTL requests . This can be exploited for privilege escalation, code execution under high privileges, and information disclosure. These signed drivers can also be used to bypass the Microsoft driver-signing policy to deploy malicious code. | ||||