| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
net: nfc: nci: Fix parameter validation for packet data
Since commit 9c328f54741b ("net: nfc: nci: Add parameter validation for
packet data") communication with nci nfc chips is not working any more.
The mentioned commit tries to fix access of uninitialized data, but
failed to understand that in some cases the data packet is of variable
length and can therefore not be compared to the maximum packet length
given by the sizeof(struct). |
| In the Linux kernel, the following vulnerability has been resolved:
EFI/CPER: don't go past the ARM processor CPER record buffer
There's a logic inside GHES/CPER to detect if the section_length
is too small, but it doesn't detect if it is too big.
Currently, if the firmware receives an ARM processor CPER record
stating that a section length is big, kernel will blindly trust
section_length, producing a very long dump. For instance, a 67
bytes record with ERR_INFO_NUM set 46198 and section length
set to 854918320 would dump a lot of data going a way past the
firmware memory-mapped area.
Fix it by adding a logic to prevent it to go past the buffer
if ERR_INFO_NUM is too big, making it report instead:
[Hardware Error]: Hardware error from APEI Generic Hardware Error Source: 1
[Hardware Error]: event severity: recoverable
[Hardware Error]: Error 0, type: recoverable
[Hardware Error]: section_type: ARM processor error
[Hardware Error]: MIDR: 0xff304b2f8476870a
[Hardware Error]: section length: 854918320, CPER size: 67
[Hardware Error]: section length is too big
[Hardware Error]: firmware-generated error record is incorrect
[Hardware Error]: ERR_INFO_NUM is 46198
[ rjw: Subject and changelog tweaks ] |
| In the Linux kernel, the following vulnerability has been resolved:
dlm: validate length in dlm_search_rsb_tree
The len parameter in dlm_dump_rsb_name() is not validated and comes
from network messages. When it exceeds DLM_RESNAME_MAXLEN, it can
cause out-of-bounds write in dlm_search_rsb_tree().
Add length validation to prevent potential buffer overflow. |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: MGMT: validate mesh send advertising payload length
mesh_send() currently bounds MGMT_OP_MESH_SEND by total command
length, but it never verifies that the bytes supplied for the
flexible adv_data[] array actually match the embedded adv_data_len
field. MGMT_MESH_SEND_SIZE only covers the fixed header, so a
truncated command can still pass the existing 20..50 byte range
check and later drive the async mesh send path past the end of the
queued command buffer.
Keep rejecting zero-length and oversized advertising payloads, but
validate adv_data_len explicitly and require the command length to
exactly match the flexible array size before queueing the request. |
| In the Linux kernel, the following vulnerability has been resolved:
netfilter: xt_tcpmss: check remaining length before reading optlen
Quoting reporter:
In net/netfilter/xt_tcpmss.c (lines 53-68), the TCP option parser reads
op[i+1] directly without validating the remaining option length.
If the last byte of the option field is not EOL/NOP (0/1), the code attempts
to index op[i+1]. In the case where i + 1 == optlen, this causes an
out-of-bounds read, accessing memory past the optlen boundary
(either reading beyond the stack buffer _opt or the
following payload). |
| Side-channel information leakage in Media in Google Chrome prior to 148.0.7778.96 allowed a remote attacker to leak cross-origin data via a crafted HTML page. (Chromium security severity: Low) |
| An issue was discovered in 6.0 before 6.0.5 and 5.2 before 5.2.14.
ASGI requests with a missing or understated `Content-Length` header can bypass the `FILE_UPLOAD_MAX_MEMORY_SIZE` limit, potentially loading large files into memory and causing service degradation.
As a reminder, Django expects a limit to be configured at the web server level rather than solely relying on `FILE_UPLOAD_MAX_MEMORY_SIZE`.
Earlier, unsupported Django series (such as 5.0.x, 4.1.x, and 3.2.x) were not evaluated and may also be affected.
Django would like to thank Kyle Agronick for reporting this issue. |
| In the Linux kernel, the following vulnerability has been resolved:
ext4: convert inline data to extents when truncate exceeds inline size
Add a check in ext4_setattr() to convert files from inline data storage
to extent-based storage when truncate() grows the file size beyond the
inline capacity. This prevents the filesystem from entering an
inconsistent state where the inline data flag is set but the file size
exceeds what can be stored inline.
Without this fix, the following sequence causes a kernel BUG_ON():
1. Mount filesystem with inode that has inline flag set and small size
2. truncate(file, 50MB) - grows size but inline flag remains set
3. sendfile() attempts to write data
4. ext4_write_inline_data() hits BUG_ON(write_size > inline_capacity)
The crash occurs because ext4_write_inline_data() expects inline storage
to accommodate the write, but the actual inline capacity (~60 bytes for
i_block + ~96 bytes for xattrs) is far smaller than the file size and
write request.
The fix checks if the new size from setattr exceeds the inode's actual
inline capacity (EXT4_I(inode)->i_inline_size) and converts the file to
extent-based storage before proceeding with the size change.
This addresses the root cause by ensuring the inline data flag and file
size remain consistent during truncate operations. |
| A heap buffer overflow vulnerability exists in the DTLS handshake fragment reassembly logic of GnuTLS. The issue arises in merge_handshake_packet() where incoming handshake fragments are matched and merged based solely on handshake type, without validating that the message_length field remains consistent across all fragments of the same logical message. An attacker can exploit this by sending crafted DTLS fragments with conflicting message_length values, causing the implementation to allocate a buffer based on a smaller initial fragment and subsequently write beyond its bounds using larger, inconsistent fragments. Because the merge operation does not enforce proper bounds checking against the allocated buffer size, this results in an out-of-bounds write on the heap. The vulnerability is remotely exploitable without authentication via the DTLS handshake path and can lead to application crashes or potential memory corruption. |
| When processing the header of an incoming message, libnv failed to properly validate the message size.
The lack of validation allows a malicious program to write outside the bounds of a heap allocation. This can trigger a crash or system panic, and it may be possible for an unprivileged user to exploit the bug to elevate their privileges. |
| When generating an ICMP Destination Unreachable or Packet Too Big response, the handler copies a portion of the original packet into the ICMP error body using the IP header's self-declared total length (ip_tot_len for IPv4, ip6_plen for IPv6) without validating it against the actual packet buffer size. A VM can send a short packet with an inflated IP length field that triggers an ICMP error (e.g., by hitting a reject ACL), causing ovn-controller to read heap memory beyond the valid packet data and include it in the ICMP response sent back to the VM. |
| A flaw was found in OVN (Open Virtual Network). A remote attacker, by sending crafted DHCPv6 (Dynamic Host Configuration Protocol for IPv6) SOLICIT packets with an inflated Client ID length, could cause the ovn-controller to read beyond the bounds of a packet. This out-of-bounds read can lead to the disclosure of sensitive information stored in heap memory, which is then returned to the attacker's virtual machine port. |
| In the Linux kernel, the following vulnerability has been resolved:
ksmbd: validate EaNameLength in smb2_get_ea()
smb2_get_ea() reads ea_req->EaNameLength from the client request and
passes it directly to strncmp() as the comparison length without
verifying that the length of the name really is the size of the input
buffer received.
Fix this up by properly checking the size of the name based on the value
received and the overall size of the request, to prevent a later
strncmp() call to use the length as a "trusted" size of the buffer.
Without this check, uninitialized heap values might be slowly leaked to
the client. |
| An improper handling of the length parameter inconsistency vulnerability has been identified in Moxa’s Secure Router. Because of improper validation of length parameters in the HTTPS management interface, an unauthenticated remote attacker could send specially crafted requests that trigger a buffer overflow condition, causing the web service to become unresponsive. Successful exploitation may result in a denial-of-service condition requiring a device reboot to restore normal operation. While successful exploitation can severely impact the availability of the affected device, no impact to the confidentiality or integrity of the affected product has been identified. Additionally, no confidentiality, integrity, or availability impact to the subsequent system has been identified. |
| rust-openssl provides OpenSSL bindings for the Rust programming language. From 0.9.24 to before 0.10.78, the FFI trampolines behind SslContextBuilder::set_psk_client_callback, set_psk_server_callback, set_cookie_generate_cb, and set_stateless_cookie_generate_cb forwarded the user closure's returned usize directly to OpenSSL without checking it against the &mut [u8] that was handed to the closure. This can lead to buffer overflows and other unintended consequences. This vulnerability is fixed in 0.10.78. |
| In the Linux kernel, the following vulnerability has been resolved:
rxrpc: fix oversized RESPONSE authenticator length check
rxgk_verify_response() decodes auth_len from the packet and is supposed
to verify that it fits in the remaining bytes. The existing check is
inverted, so oversized RESPONSE authenticators are accepted and passed
to rxgk_decrypt_skb(), which can later reach skb_to_sgvec() with an
impossible length and hit BUG_ON(len).
Decoded from the original latest-net reproduction logs with
scripts/decode_stacktrace.sh:
RIP: __skb_to_sgvec()
[net/core/skbuff.c:5285 (discriminator 1)]
Call Trace:
skb_to_sgvec() [net/core/skbuff.c:5305]
rxgk_decrypt_skb() [net/rxrpc/rxgk_common.h:81]
rxgk_verify_response() [net/rxrpc/rxgk.c:1268]
rxrpc_process_connection()
[net/rxrpc/conn_event.c:266 net/rxrpc/conn_event.c:364
net/rxrpc/conn_event.c:386]
process_one_work() [kernel/workqueue.c:3281]
worker_thread()
[kernel/workqueue.c:3353 kernel/workqueue.c:3440]
kthread() [kernel/kthread.c:436]
ret_from_fork() [arch/x86/kernel/process.c:164]
Reject authenticator lengths that exceed the remaining packet payload. |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: L2CAP: Validate L2CAP_INFO_RSP payload length before access
l2cap_information_rsp() checks that cmd_len covers the fixed
l2cap_info_rsp header (type + result, 4 bytes) but then reads
rsp->data without verifying that the payload is present:
- L2CAP_IT_FEAT_MASK calls get_unaligned_le32(rsp->data), which reads
4 bytes past the header (needs cmd_len >= 8).
- L2CAP_IT_FIXED_CHAN reads rsp->data[0], 1 byte past the header
(needs cmd_len >= 5).
A truncated L2CAP_INFO_RSP with result == L2CAP_IR_SUCCESS triggers an
out-of-bounds read of adjacent skb data.
Guard each data access with the required payload length check. If the
payload is too short, skip the read and let the state machine complete
with safe defaults (feat_mask and remote_fixed_chan remain zero from
kzalloc), so the info timer cleanup and l2cap_conn_start() still run
and the connection is not stalled. |
| In the Linux kernel, the following vulnerability has been resolved:
nfnetlink_osf: validate individual option lengths in fingerprints
nfnl_osf_add_callback() validates opt_num bounds and string
NUL-termination but does not check individual option length fields.
A zero-length option causes nf_osf_match_one() to enter the option
matching loop even when foptsize sums to zero, which matches packets
with no TCP options where ctx->optp is NULL:
Oops: general protection fault
KASAN: null-ptr-deref in range [0x0000000000000000-0x0000000000000007]
RIP: 0010:nf_osf_match_one (net/netfilter/nfnetlink_osf.c:98)
Call Trace:
nf_osf_match (net/netfilter/nfnetlink_osf.c:227)
xt_osf_match_packet (net/netfilter/xt_osf.c:32)
ipt_do_table (net/ipv4/netfilter/ip_tables.c:293)
nf_hook_slow (net/netfilter/core.c:623)
ip_local_deliver (net/ipv4/ip_input.c:262)
ip_rcv (net/ipv4/ip_input.c:573)
Additionally, an MSS option (kind=2) with length < 4 causes
out-of-bounds reads when nf_osf_match_one() unconditionally accesses
optp[2] and optp[3] for MSS value extraction. While RFC 9293
section 3.2 specifies that the MSS option is always exactly 4
bytes (Kind=2, Length=4), the check uses "< 4" rather than
"!= 4" because lengths greater than 4 do not cause memory
safety issues -- the buffer is guaranteed to be at least
foptsize bytes by the ctx->optsize == foptsize check.
Reject fingerprints where any option has zero length, or where an MSS
option has length less than 4, at add time rather than trusting these
values in the packet matching hot path. |
| Stack-based buffer overflow in the script_write_params method in client/dhclient.c in ISC DHCP dhclient 4.1 before 4.1.0p1, 4.0 before 4.0.1p1, 3.1 before 3.1.2p1, 3.0, and 2.0 allows remote DHCP servers to execute arbitrary code via a crafted subnet-mask option. |
| The asn1buf_imbed function in the ASN.1 decoder in MIT Kerberos 5 (aka krb5) 1.6.3, when PK-INIT is used, allows remote attackers to cause a denial of service (application crash) via a crafted length value that triggers an erroneous malloc call, related to incorrect calculations with pointer arithmetic. |
