| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| The DHCP relay subsystem of Cisco IOS 12.2 through 15.6 and Cisco IOS XE Software contains a vulnerability that could allow an unauthenticated, remote attacker to execute arbitrary code and gain full control of an affected system. The attacker could also cause an affected system to reload, resulting in a denial of service (DoS) condition. The vulnerability is due to a buffer overflow condition in the DHCP relay subsystem of the affected software. An attacker could exploit this vulnerability by sending a crafted DHCP Version 4 (DHCPv4) packet to an affected system. A successful exploit could allow the attacker to execute arbitrary code and gain full control of the affected system or cause the affected system to reload, resulting in a DoS condition. Cisco Bug IDs: CSCsm45390, CSCuw77959. |
| A vulnerability in the implementation of Network Address Translation (NAT) functionality in Cisco IOS 12.4 through 15.6 could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on an affected device. The vulnerability is due to the improper translation of H.323 messages that use the Registration, Admission, and Status (RAS) protocol and are sent to an affected device via IPv4 packets. An attacker could exploit this vulnerability by sending a crafted H.323 RAS packet through an affected device. A successful exploit could allow the attacker to cause the affected device to crash and reload, resulting in a DoS condition. This vulnerability affects Cisco devices that are configured to use an application layer gateway with NAT (NAT ALG) for H.323 RAS messages. By default, a NAT ALG is enabled for H.323 RAS messages. Cisco Bug IDs: CSCvc57217. |
| Cisco IOS 12.2(15) and earlier allows remote attackers to cause a denial of service (refused VTY (virtual terminal) connections), via a crafted TCP connection to the Telnet or reverse Telnet port. |
| Classic Cisco IOS 9.1 and later allows attackers with access to the login prompt to obtain portions of the command history of previous users, which may allow the attacker to access sensitive data. |
| The design of the Hot Standby Routing Protocol (HSRP), as implemented on Cisco IOS 12.1, when using IRPAS, allows remote attackers to cause a denial of service (CPU consumption) via a router with the same IP address as the interface on which HSRP is running, which causes a loop. |
| Unspecified vulnerability in the VLAN Trunking Protocol (VTP) feature in Cisco IOS 12.1(22)EA3 on Catalyst 2950T switches allows remote attackers to cause a denial of service (device reboot) via a crafted Subset-Advert message packet, a different issue than CVE-2006-4774, CVE-2006-4775, and CVE-2006-4776. |
| Cisco 2611 router running IOS 12.1(6.5), possibly an interim release, allows remote attackers to cause a denial of service via port scans such as (1) scanning all ports on a single host and (2) scanning a network of hosts for a single open port through the router. NOTE: the vendor could not reproduce this issue, saying that the original reporter was using an interim release of the software. |
| Multiple SSH2 servers and clients do not properly handle lists with empty elements or strings, which may allow remote attackers to cause a denial of service or possibly execute arbitrary code, as demonstrated by the SSHredder SSH protocol test suite. |
| The Cisco Optical Service Module (OSM) for the Catalyst 6500 and 7600 series running Cisco IOS 12.1(8)E through 12.1(13.4)E allows remote attackers to cause a denial of service (hang) via a malformed packet. |
| Unspecified Cisco Catalyst Switches allow remote attackers to cause a denial of service (device crash) via an IP packet with the same source and destination IPs and ports, and with the SYN flag set (aka LanD). NOTE: the provenance of this issue is unknown; the details are obtained solely from the BID. |
| Cisco IOS 12.0 to 12.4 might allow remote attackers to execute arbitrary code via a heap-based buffer overflow in system timers. NOTE: this issue does not correspond to a specific vulnerability, rather a general weakness that only increases the feasibility of exploitation of any vulnerabilities that might exist. Such design-level weaknesses normally are not included in CVE, so perhaps this issue should be REJECTed. |
| Cisco IOS 12.0 through 12.2, when supporting SSH, allows remote attackers to cause a denial of service (CPU consumption) via a large packet that was designed to exploit the SSH CRC32 attack detection overflow (CVE-2001-0144). |
| Cisco IOS 12.2T through 12.4 allows remote attackers to bypass Authentication, Authorization, and Accounting (AAA) RADIUS authentication, if the fallback method is set to none, via a long username. |
| Buffer overflow in Cisco 7xx routers through the telnet service. |
| Buffer overflow in Cisco TACACS+ tac_plus server allows remote attackers to cause a denial of service via a malformed packet with a long length field. |
| Some classic Cisco IOS devices have a vulnerability in the PPP CHAP authentication to establish unauthorized PPP connections. |
| Cisco PIX firewall and CBAC IP fragmentation attack results in a denial of service. |
| Cisco IOS 12.2T, 12.3 and 12.3T, when processing an ISAKMP profile that specifies XAUTH authentication after Phase 1 negotiation, may not process certain attributes in the ISAKMP profile that specifies XAUTH, which allows remote attackers to bypass XAUTH and move to Phase 2 negotiations. |
| Heap-based buffer overflow in the TFTP server capability in Cisco IOS 11.1, 11.2, and 11.3 allows remote attackers to cause a denial of service (reset) or modify configuration via a long filename. |
| Cisco IOS 12.0 and other versions can be crashed by malicious UDP packets to the syslog port. |
