| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
xfrm: clear mode callbacks after failed mode setup
xfrm_state_gc_task can run long after a failed IPTFS state setup. In the
reproduced case, __xfrm_init_state() cached x->mode_cbs, IPTFS setup
returned -ENOMEM before publishing mode_data, and the temporary module
reference from xfrm_get_mode_cbs() was dropped immediately. The dead state
then kept x->mode_cbs until deferred GC ran after xfrm_iptfs had been
unloaded.
Clear x->mode_cbs when mode init or clone fails before publishing
mode_data. Those states never installed mode-specific state or the
long-term IPTFS module pin, so deferred GC has nothing mode-specific to
destroy and must not retain a callback table pointer past the temporary
lookup reference.
The buggy scenario involves two paths, with each column showing the order
within that path:
failed setup path:
1. cache x->mode_cbs
2. mode setup fails before mode_data
3. drop the temporary module ref
4. dead state keeps x->mode_cbs cached
GC/unload path:
1. xfrm_state_put() queues GC work
2. xfrm_iptfs unloads later
3. xfrm_state_gc_task runs
4. GC dereferences stale x->mode_cbs
This also covers the failed clone path where clone_state() returns before
publishing mode_data.
Validation reproduced this kernel report:
Kernel panic - not syncing: Fatal exception
CONFIG_FAULT_INJECTION_STACKTRACE_FILTER=y
failslab_stacktrace_filter matched xfrm_iptfs frames
ack_error=-12
FAULT_INJECTION: forcing a failure
BUG: unable to handle page fault
Workqueue: events xfrm_state_gc_task
RIP: xfrm_state_gc_task+0x142/0x650
Modules linked in: esp4_offload xfrm_user [last unloaded: xfrm_iptfs]
Kernel panic - not syncing: Fatal exception |
| In the Linux kernel, the following vulnerability has been resolved:
IB/mad: Drop unmatched RMPP responses before reassembly
Kernel-handled RMPP receive processing starts reassembly for active
DATA responses before the response is matched to an outstanding send.
The normal match happens later, after ib_process_rmpp_recv_wc() has
either assembled a complete message or consumed the segment.
That ordering lets an unsolicited response that routes to a kernel
RMPP agent by the high TID bits allocate or extend RMPP receive state
before the full TID and source address are checked against a real
request. A reordered burst can therefore reach the receive-side
insertion path even though the response would not match any send.
For kernel-handled RMPP DATA responses, require the existing
ib_find_send_mad() match before entering RMPP reassembly. The matcher
already checks the full TID, management class and source address/GID
against the agent wait, backlog and in-flight send lists. If there is
no match, drop the response without creating RMPP state.
This leaves the RMPP window behavior unchanged and only rejects
responses that have no corresponding request. |
| In the Linux kernel, the following vulnerability has been resolved:
vxlan: require CAP_NET_ADMIN in the device netns for changelink
A tunnel changelink() operates on at most two netns, dev_net(dev) and
the sticky underlay netns vxlan->net. They differ once the device is
created in or moved to a netns other than the one the request runs in.
The rtnl changelink path checks CAP_NET_ADMIN only against dev_net(dev),
so a caller privileged there but not in vxlan->net can rewrite a vxlan
device whose underlay lives in vxlan->net.
vxlan_changelink() validates and applies the new configuration against
vxlan->net (vxlan_config_validate(vxlan->net, ...)) and can reopen the
underlay socket in that netns, so the same reasoning as the tunnel
changelink series applies here.
Gate vxlan_changelink() with rtnl_dev_link_net_capable(), at the top of
the op before any attribute is parsed, matching ipgre_changelink() and
the rest of the "require CAP_NET_ADMIN in the device netns for
changelink" series.
Found by 0sec automated security-research tooling (https://0sec.ai). |
| An authentication issue was addressed with improved state management. This issue is fixed in macOS Sequoia 15.7.9, macOS Sonoma 14.8.9, macOS Tahoe 26.6.1. An attacker on the network may be able to authenticate to Screen Sharing without valid credentials. |
| Previously, pathological inputs could close an unescaped '/' early, allowing for attack-controlled data to inject arbitrary content, potentially leading to XSS. |
| A weakness has been identified in itsourcecode Hospital Management System 1.0. This issue affects some unknown processing of the file viewdoctortimings.php. Executing a manipulation of the argument delid can lead to sql injection. The attack may be performed from remote. The exploit has been made available to the public and could be used for attacks. |
| A security flaw has been discovered in eyaushev swagger-testcase-mcp 5babb27c951fb404bc2b25ec80593616e49054e5. This vulnerability affects the function loadSource of the file src/utils/swagger-parser.ts of the component fetch_swagger. Performing a manipulation results in server-side request forgery. The attack is possible to be carried out remotely. The exploit has been released to the public and may be used for attacks. This product adopts a rolling release strategy to maintain continuous delivery. Therefore, version details for affected or updated releases cannot be specified. The project was informed of the problem early through an issue report but has not responded yet. |
| In the Linux kernel, the following vulnerability has been resolved:
rds: tcp: unregister sysctl before tearing down listen socket
rds_tcp_exit_net() frees the per-netns RDS TCP listen socket via
rds_tcp_kill_sock() before unregistering the per-netns sysctl table. Since
rds_tcp_skbuf_handler() derives the netns from
rtn->rds_tcp_listen_sock->sk, a concurrent sysctl write can race with
netns teardown and dereference the freed socket/sk.
KASAN reports the race as:
BUG: KASAN: slab-use-after-free in rds_tcp_skbuf_handler+0x2aa/0x2e0
rds_tcp_skbuf_handler net/rds/tcp.c:721
proc_sys_call_handler fs/proc/proc_sysctl.c
vfs_write fs/read_write.c
__x64_sys_pwrite64 fs/read_write.c
Fix this by unregistering the RDS TCP sysctl table before calling
rds_tcp_kill_sock(). unregister_net_sysctl_table() prevents new sysctl
handlers from starting and waits for in-flight handlers to finish, so
the listen socket can then be released safely. The fix was tested
against the linked reproducer. |
| In the Linux kernel, the following vulnerability has been resolved:
net/mlx5: Fix MCIA register buffer overflow on 32 dword reads
The MCIA register can return up to 32 dwords (128 bytes) when the device
advertises the mcia_32dwords capability, but struct
mlx5_ifc_mcia_reg_bits only defines dword_0..11, leaving room for just
12 dwords (48 bytes) of data.
mlx5_query_mcia() clamps the read size to mlx5_mcia_max_bytes() and then
memcpy()s that many bytes out of the register, potentially reading past
the end of the 'out' buffer. On kernels built with FORTIFY_SOURCE this
is caught as a buffer overflow while reading the module EEPROM via
ethtool:
detected buffer overflow in memcpy
kernel BUG at lib/string_helpers.c:1048!
RIP: 0010:fortify_panic+0x13/0x20
Call Trace:
mlx5_query_mcia.isra.0+0x200/0x210 [mlx5_core]
mlx5_query_module_eeprom_by_page+0x4a/0xa0 [mlx5_core]
mlx5e_get_module_eeprom_by_page+0xbb/0x120 [mlx5_core]
eeprom_prepare_data+0xf3/0x170
ethnl_default_doit+0xf1/0x3b0
Extend the mcia_reg layout to 32 dwords. |
| A vulnerability was identified in Raisecom Communication Command and Dispatch Management Platform up to 7.6.5. This affects an unknown part of the file /app/users/getpwd.php. Such manipulation of the argument sip leads to sql injection. The attack can be executed remotely. The exploit is publicly available and might be used. The vendor was contacted early about this disclosure but did not respond in any way. |
| `xml.parsers.expat` and `xml.etree.ElementTree` use insufficient entropy for Expat hash-flooding protection, which allows a crafted XML document to trigger hash flooding.\r\n\r\nFully mitigating this vulnerability requires both updating libexpat to 2.8.0 or later and applying this patch. |
| A stack buffer overflow vulnerability was found in GStreamer's DTLS plugin. During a DTLS handshake, the peer certificate Subject Distinguished Name is printed into a fixed-size 2048-byte stack buffer without bounds checking. A remote unauthenticated attacker can send a certificate with an oversized Subject DN that exceeds the buffer, causing a stack buffer overflow and process crash, resulting in denial of service. |
| A heap buffer overflow vulnerability was found in GStreamer's rfbsrc plugin. When a client connects to a malicious RFB/VNC server that advertises a 16bpp framebuffer and sends Hextile-encoded updates, the Hextile background fill path writes 32-bit pixel values into a buffer allocated for 16-bit pixels. This type mismatch causes an out-of-bounds heap write that can lead to denial of service (process crash) and potential memory corruption. |
| A vulnerability was determined in DTStack Taier 1.4.0. Affected by this issue is the function FileUtils.deleteDirectory of the file ClusterController.java of the component Cluster Creation. This manipulation of the argument clusterName causes path traversal. Remote exploitation of the attack is possible. Upgrading to version 1.5.0 can resolve this issue. Patch name: ec8c59c76aceb04ab3080543ab2d9c6a4b674729. The affected component should be upgraded. |
| Handshake messages, such as KeyUpdate, are always considered as state-advancing, regardless of whether a handshake has been completed or not. As a result, a malicious client can keep sending KeyUpdate messages to force the server to keep performing key derivation operations indefinitely. |
| Previously, resolving relative paths containing parent directory ('..') segments performed string conversions and buffer rewrites on each step, resulting in quadratic time complexity and high memory allocation overhead. Now, path resolution operates on a byte buffer using index-based backtracking for '..' segments, eliminating the quadratic time complexity and significantly reducing memory allocations. |
| OpenWrt LuCI contains an overly permissive ACL definition in luci-mod-system-mounts that grants write access to /etc/crontabs/root to users intended only for mount configuration. Authenticated users with only the mount-configuration ACL group can append arbitrary cron entries via ubus file.write, which the default busybox crond daemon executes as root within one minute. |
| luci-app-openvpn fails to properly validate the instance_name2 parameter during file upload, allowing authenticated users to perform path traversal and write arbitrary files outside the intended directory. Attackers can upload malicious payloads to gain persistent root code execution by placing SSH keys in system directories accessible on reboot. |
| Russh is a Rust SSH client & server library. Prior to 0.62.4, an authenticated SSH client can cause a denial of service by sending a pty-req channel request with more than 130 terminal-mode records. The parser in russh/src/server/encrypted.rs stores terminal modes in a fixed 130-entry [(Pty::TTY_OP_END, 0); 130] array but continues increasing the mode count, then constructs an out-of-bounds slice and panics before the application pty_request handler runs. The panic terminates the server session task without causing memory corruption. This issue is fixed in version 0.62.4. |
| A vulnerability was found in DTStack Taier 1.4.0. Affected by this vulnerability is the function Paths.ge of the file FileChunkController.java of the component Chunk-Check Endpoint. The manipulation of the argument Name results in path traversal. The attack may be launched remotely. The exploit has been made public and could be used. |
