| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| IBM AIX 7.2, and 7.3 and IBM PowerVM VIOS 4.1 has a pointer validation flaw exists in the AIX Virtual SCSI (vSCSI) initiator driver. Successful exploitation may result in denial of service, privilege escalation, or full compromise of the client LPAR kernel. |
| IBM AIX 7.2, and 7.3 and IBM PowerVM VIOS 4.1 could allow a local attacker to gain elevated privileges due to an out-of-bounds write. |
| IBM AIX 7.2, and 7.3 and IBM PowerVM VIOS 4.1 could allow a local attacker to execute arbitrary code due to improper validation of an attacker-controlled pointer. |
| IBM AIX 7.2, and 7.3 and IBM PowerVM VIOS 4.1 could allow a remote authenticated attacker to execute arbitrary commands due to improper neutralization of special elements used in an OS command. |
| IBM AIX 7.2, and 7.3 and IBM PowerVM VIOS 4.1 could allow a local authenticated attacker to execute arbitrary code due to a heap-based buffer overflow. |
| IBM Power Systems Firmware FW1120.00, FW1110.00 through FW1110.30, FW1060.00 through FW1060.80, FW950.00 through FW950.H2, OP940.00 through OP940.a1 (Power9), and OP940.00 through OP940.81 (Power HMC) is affected by a vulnerability in the interface between the BMC/FSP and the host system. An attacker with service account or root access to the BMC/FSP can read and write arbitrary regions of host system memory, giving full control over the host system and all hosted partitions, resulting in a confidentiality, integrity, and availability impact. |
| IBM Power Systems Firmware FW1120.00, FW1110.00 through FW1110.30, and FW1060.00 through FW1060.80 is affected by a vulnerability in the interface between the BMC/FSP and the host system. An attacker with service account or root access to the BMC/FSP can execute arbitrary code on the host system, giving full control over the host system and all hosted partitions, resulting in a confidentiality, integrity, and availability impact. |
| IBM AIX 7.2, and 7.3 and IBM PowerVM VIOS 4.1 could allow a remote attacker to execute arbitrary commands due to improper neutralization of special elements used in an OS command. |
| IBM AIX 7.2, and 7.3 and IBM PowerVM VIOS 4.1 could allow a remote attacker to execute arbitrary code due to an out-of-bounds write. |
| IBM PowerVM Hypervisor FW1120.00, FW1110.00 through FW1110.30, FW1060.00 through FW1060.80, and FW950.00 through FW950.H2 is affected by a vulnerability in the service processor mailbox interface. An attacker with authenticated service-level access to the FSP can exploit this vulnerability, allowing arbitrary code to be executed in the host firmware runtime, giving full control over the managed system, resulting in a confidentiality, integrity, and availability impact to the managed system. |
| In the Linux kernel, the following vulnerability has been resolved:
netfilter: ipset: fix order of kfree_rcu() and rcu_assign_pointer()
Sashiko pointed out that kfree_rcu() was called before
rcu_assign_pointer() in handling the comment extension.
Fix the order so that rcu_assign_pointer() called first. |
| In the Linux kernel, the following vulnerability has been resolved:
md/raid10: fix writes_pending leak on write request failures
raid10_make_request() acquires a writes_pending reference with
md_write_start() before dispatching write requests. Several failure
paths in raid10_write_request() complete the bio and return without
reaching the normal write completion path, causing the corresponding
md_write_end() to be skipped.
Make raid10_write_request() return a status indicating whether the write
request was successfully queued. This allows raid10_make_request() to
release the writes_pending reference with md_write_end() when a write
request fails. |
| In the Linux kernel, the following vulnerability has been resolved:
md/raid1: fix writes_pending and barrier reference leaks on write failures
raid1_make_request() acquires a writes_pending reference with
md_write_start() before calling raid1_write_request(). Several failure
paths in raid1_write_request() complete the bio and return without
reaching the normal write completion path, causing the corresponding
md_write_end() to be skipped.
Make raid1_write_request() return a status indicating whether the write
request was successfully queued. This allows raid1_make_request() to
call md_write_end() when raid1_write_request() fails.
Additionally, if wait_blocked_rdev() fails after wait_barrier()
succeeds, the associated barrier reference is not released.
Call allow_barrier() before returning from that path to keep the barrier
accounting balanced. |
| In the Linux kernel, the following vulnerability has been resolved:
ieee802154: fix kernel-infoleak in dgram_recvmsg()
KMSAN reported a kernel-infoleak in move_addr_to_user():
BUG: KMSAN: kernel-infoleak in instrument_copy_to_user
include/linux/instrumented.h:131 [inline]
BUG: KMSAN: kernel-infoleak in _inline_copy_to_user
include/linux/uaccess.h:205 [inline]
BUG: KMSAN: kernel-infoleak in _copy_to_user+0xcc/0x120
lib/usercopy.c:26
instrument_copy_to_user include/linux/instrumented.h:131 [inline]
_inline_copy_to_user include/linux/uaccess.h:205 [inline]
_copy_to_user+0xcc/0x120 lib/usercopy.c:26
copy_to_user include/linux/uaccess.h:236 [inline]
move_addr_to_user+0x2e7/0x440 net/socket.c:302
____sys_recvmsg+0x232/0x610 net/socket.c:2925
...
Uninit was stored to memory at:
ieee802154_addr_to_sa include/net/ieee802154_netdev.h:369 [inline]
dgram_recvmsg+0xa09/0xbe0 net/ieee802154/socket.c:739
The issue occurs because the `pan_id` field of `struct ieee802154_addr`
is left uninitialized when the address mode is `IEEE802154_ADDR_NONE`.
The execution flow is as follows:
1. `__ieee802154_rx_handle_packet()` declares a local `struct
ieee802154_hdr hdr` on the stack.
2. `ieee802154_hdr_pull()` calls `ieee802154_hdr_get_addr()` to parse
the source and destination addresses into this structure.
3. If the address mode is `IEEE802154_ADDR_NONE`,
`ieee802154_hdr_get_addr()` previously only set the `mode` field,
leaving the `pan_id` field containing uninitialized stack memory.
4. This uninitialized `pan_id` is later copied into a `struct
sockaddr_ieee802154` in `dgram_recvmsg()` via `ieee802154_addr_to_sa()`.
5. Finally, `move_addr_to_user()` copies the socket address structure to
user space, leaking the uninitialized bytes.
Fix this by using `memset` to zero out the address structure in
`ieee802154_hdr_get_addr()` when the mode is `IEEE802154_ADDR_NONE`. |
| In the Linux kernel, the following vulnerability has been resolved:
ALSA: usb-audio: qcom: reject stream disable with no active interface
handle_uaudio_stream_req() resolves an interface index with
info_idx_from_ifnum(), which returns -EINVAL when no interface matches.
The enable branch and the response: cleanup label both guard against a
negative index, but the disable branch does not: it forms
info = &uadev[pcm_card_num].info[info_idx] and dereferences it.
uadev[].info is a pointer allocated only when a stream is first enabled,
so a negative info_idx on the disable path is unsafe in two ways:
- If the card was never enabled, .info is NULL and &info[-EINVAL] is a
wild pointer; reading info->data_ep_pipe faults (kernel oops).
- If the card was enabled at least once (.info allocated) and the
disable names an interface that does not match, &info[-EINVAL] points
before the allocation; info->data_ep_pipe / info->sync_ep_pipe are an
out-of-bounds slab read and, when non-zero, an out-of-bounds 4-byte
write (both pipe fields are cleared to 0). That is memory corruption,
not just a NULL dereference.
The request is reachable from unprivileged local userspace over
AF_QIPCRTR. Reject a disable request with no resolved interface, matching
the guard the enable path already has. |
| In the Linux kernel, the following vulnerability has been resolved:
sctp: hold socket lock when dumping endpoints in sctp_diag
SCTP_DIAG endpoint dumping was traversing endpoint address lists without
holding lock_sock(), while those lists could change concurrently via
socket operations (e.g., bindx changes). This creates a race where
nla_reserve() counts addresses under RCU protection, but the subsequent
copy may see fewer entries, potentially leaking uninitialized memory to
userspace.
Fix this by:
- Taking a reference on each endpoint during hash traversal
- Moving socket operations (lock_sock()) outside read_lock_bh()
- Serializing address list access during dump
- Reworking sctp_for_each_endpoint() to support restart-based traversal
with (net, pos) tracking
Also:
- Add WARN_ON_ONCE() for inconsistent address counts
- Fix idiag_states filtering for LISTEN vs association cases
- Skip dumping endpoints being freed (ep->base.dead)
- Move dump position tracking into iterator, removing cb->args[4] and
its comment for sctp_ep_dump().,
- Update the comment for cb->args[4] and remove the comment for unused
cb->args[5] for sctp_sock_dump().
Note: traversal is restart-based and may re-scan buckets multiple times,
but this is acceptable due to small bucket sizes and required to support
sleeping-safe callbacks.
This issue was reported by Nico Yip (@_cyeaa_) working with TrendAI Zero
Day Initiative. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/amdkfd: fix list_del corruption in kfd_criu_resume_svm
The cleanup tail of kfd_criu_resume_svm() walks
svms->criu_svm_metadata_list and kfree()s each struct criu_svm_metadata
without removing it from the list. The list head is left pointing at
freed kmalloc-96 objects.
A second AMDKFD_IOC_CRIU_OP from the same process re-enters: list_empty()
reads the dangling ->next (use-after-free), the loop walks freed entries,
and each is kfree()'d again (double-free). This is reachable by an
unprivileged render-group user via /dev/kfd with no capabilities required.
Add list_del() before the kfree() so the list is properly emptied. The
list_for_each_entry_safe() iterator already caches the next pointer, so
unlinking during the walk is safe.
(cherry picked from commit 6322d278a298e2c1430b9d2697743d3a04b788b1) |
| In the Linux kernel, the following vulnerability has been resolved:
xfrm: validate selector family and prefixlen during match
syzbot reported a shift-out-of-bounds in xfrm_selector_match()
due to AF_UNSPEC selector with large prefixlen (e.g. 128) matched
against IPv4 flow (when XFRM_STATE_AF_UNSPEC is set).
Fix this by:
- Rejecting mismatched families in xfrm_selector_match.
- Returning false in addr4_match if prefixlen > 32.
- Returning false in addr_match if prefixlen > 128 (prevents overflow). |
| In the Linux kernel, the following vulnerability has been resolved:
xfrm: Fix xfrm state cache insertion race
The xfrm input state cache insertion code checks the validity of
the state before acquiring the global xfrm_state_lock. Thus it's
possible for someone else to kill the state after it passed the
validity check, and then the insertion will add the dead state
to the cache.
Fix this by moving the validity check inside the lock.
This entire function is called on the input path, where BH must
be off (e.g., the caller of this function xfrm_input acquires
its spinlocks without disabling BH).
So there is no need to disable BH here or take the RCU read lock.
Remove both and replace them with an assertion that trips if BH
is accidentally enabled on some future calling path. |
| In the Linux kernel, the following vulnerability has been resolved:
regcache: Do not overwrite error code when finalizing cache after error
During regcache initialization, if an error occurs in the
cache_ops->populate callback, and if cache operations include an exit
callback, the error code from populate() is overwritten with the return
value from exit(). This hides the error condition from the caller of
regcache_init(), and can cause NULL pointer dereferences when the regcache
is later accessed. |
