| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| On affected platforms with hardware IPSec support running Arista EOS with certain IPsec features enabled, EOS may exhibit unexpected behavior in specific cases. Physical interface flaps and certain agent restarts can cause IPsec tunnel re-establishment with existing Security Associations, resulting in sequence number mismatches between tunnel endpoints potentially causing unstable communication. |
| In Arista’s EOS when in 802.1X mode, multi-auth unauthenticated hosts might be allowed access to a switch port if there exists an EAPOL capable device in the fallback VLAN. |
| On affected platforms running Arista EOS with IPsec configured, a specially crafted packet can cause the dataplane to stop processing all IPsec traffic. The control plane may detect this condition, and attempt to reset the IPsec processing pipeline. After reset traffic may not resume being processed. There is no impact to non-IPsec traffic or to IPsec traffic not originating or terminating on the system. This issue was reported by an Arista customer. |
| On affected platforms running Arista EOS with 802.1x authentication configured on the access/trunk ports, and routing enabled on the access VLAN of the ports, a malicious supplicant may be able to bypass the requirement to perform 802.1x authentication. |
| Affected platforms running Arista EOS with OpenConfig configured, a gNMI Set request can be run when it should have been rejected. This can result in unexpected configuration being applied to the switch. |
| Affected platforms running Arista EOS with OpenConfig configured, a gNMI Set request can be run when it should have been rejected. This can result in unexpected configuration being applied to the switch. |
| On affected platforms running Arista EOS with MACsec and egress ACLs configured on the same interfaces, the ACL policies may not be enforced for packets egressing on those ports. This can cause outgoing packets to incorrectly be allowed or denied. |
| This advisory documents the impact of an internally found vulnerability in Arista EOS for security ACL bypass. The impact of this vulnerability is that the security ACL drop rule might be bypassed if a NAT ACL rule filter with permit action matches the packet flow. This could allow a host with an IP address in a range that matches the range allowed by a NAT ACL and a range denied by a Security ACL to be forwarded incorrectly as it should have been denied by the Security ACL. This can enable an ACL bypass. |
| GNU Bash through 4.3 processes trailing strings after function definitions in the values of environment variables, which allows remote attackers to execute arbitrary code via a crafted environment, as demonstrated by vectors involving the ForceCommand feature in OpenSSH sshd, the mod_cgi and mod_cgid modules in the Apache HTTP Server, scripts executed by unspecified DHCP clients, and other situations in which setting the environment occurs across a privilege boundary from Bash execution, aka "ShellShock." NOTE: the original fix for this issue was incorrect; CVE-2014-7169 has been assigned to cover the vulnerability that is still present after the incorrect fix. |
| GNU Bash through 4.3 bash43-025 processes trailing strings after certain malformed function definitions in the values of environment variables, which allows remote attackers to write to files or possibly have unknown other impact via a crafted environment, as demonstrated by vectors involving the ForceCommand feature in OpenSSH sshd, the mod_cgi and mod_cgid modules in the Apache HTTP Server, scripts executed by unspecified DHCP clients, and other situations in which setting the environment occurs across a privilege boundary from Bash execution. NOTE: this vulnerability exists because of an incomplete fix for CVE-2014-6271. |
| On affected platforms running Arista EOS with OpenConfig configured, a gNOI request can be run when it should have been rejected. This issue can result in unexpected configuration/operations being applied to the switch. |
| On affected platforms running Arista EOS, certain serial console input might result in an unexpected reload of the device.153 |
| On affected platforms running Arista EOS, the global common encryption key configuration may be logged in clear text, in local or remote accounting logs. Knowledge of both the encryption key and protocol specific encrypted secrets from the device running-config could then be used to obtain protocol specific passwords in cases where symmetric passwords are required between devices with neighbor protocol relationships. |
| On affected platforms running Arista EOS with OSPFv3 configured, a specially crafted packet can cause the OSFPv3 process to have high CPU utilization which may result in the OSFPv3 process being restarted. This may cause disruption in the OSFPv3 routes on the switch.
This issue was discovered internally by Arista and is not aware of any malicious uses of this issue in customer networks. |
| On affected platforms running Arista EOS, maliciously formed UDP packets with source port 3503 may be accepted by EOS. UDP Port 3503 is associated with LspPing Echo Reply. This can result in unexpected behaviors, especially for UDP based services that do not perform some form of authentication. |
| On affected platforms running Arista EOS with Traffic Policies configured the vulnerability will cause received untagged packets not to hit Traffic Policy rules that they are expected to hit. If the rule was to drop the packet, the packet will not be dropped and instead will be forwarded as if the rule was not in place. This could lead to packets being delivered to unexpected destinations. |
| On affected platforms running Arista EOS with MACsec configuration, a specially crafted packet can cause the MACsec process to terminate unexpectedly. Continuous receipt of these packets with certain MACsec configurations can cause longer term disruption of dataplane traffic. |
| utility.c in telnetd in netkit telnet through 0.17 allows remote attackers to execute arbitrary code via short writes or urgent data, because of a buffer overflow involving the netclear and nextitem functions. |
| A flaw was found in dnsmasq before version 2.83. When receiving a query, dnsmasq does not check for an existing pending request for the same name and forwards a new request. By default, a maximum of 150 pending queries can be sent to upstream servers, so there can be at most 150 queries for the same name. This flaw allows an off-path attacker on the network to substantially reduce the number of attempts that it would have to perform to forge a reply and have it accepted by dnsmasq. This issue is mentioned in the "Birthday Attacks" section of RFC5452. If chained with CVE-2020-25684, the attack complexity of a successful attack is reduced. The highest threat from this vulnerability is to data integrity. |
| A flaw was found in dnsmasq before version 2.83. When getting a reply from a forwarded query, dnsmasq checks in forward.c:reply_query(), which is the forwarded query that matches the reply, by only using a weak hash of the query name. Due to the weak hash (CRC32 when dnsmasq is compiled without DNSSEC, SHA-1 when it is) this flaw allows an off-path attacker to find several different domains all having the same hash, substantially reducing the number of attempts they would have to perform to forge a reply and get it accepted by dnsmasq. This is in contrast with RFC5452, which specifies that the query name is one of the attributes of a query that must be used to match a reply. This flaw could be abused to perform a DNS Cache Poisoning attack. If chained with CVE-2020-25684 the attack complexity of a successful attack is reduced. The highest threat from this vulnerability is to data integrity. |
